|
The above assumes batteries are good and were
fully charged when put in storage. It also assumes water level in the
batteries is correct. It also assumes NOTHING in the
RV is consuming
battery power. Note--particularly,
the things people don't pay any attention to: TV antenna booster? Digital
clock? 12V TV and Radios? (even if TV/radios and similar are turned "off,"
some continue to use battery power to run the memory that stores preset
stations, etc.). Reefer? (again, even if off, some models continue battery
power to circuit board). Make sure "Kill Switch" (if your MH has one) is
in proper position. Gas valve? (If you have an automatic gas shut-off
valve, it will use a LOT of battery power. Best/easiest way to avoid these
"phantom" loads is to pull fuses.
Do NOT attempt to rely on your
RV converter as
a battery charger unless you have one of the rare
RVs that
actually has a user adjustable, multi-stage battery charger as part of
your converter or as an independent unit. Standard
RV converters
will either cook your batteries or fail to charge them fully. In either
case they will die. If you have old, cheap
RV batteries,
it's often easier (and economical) to remove them or just let them sit
without charging and replace them when you return.
To make things easier on caretaker, you
might invest in a digital volt meter. You can get a cheapie from Radio
Shack that reads to one decimal point for $20. Far better, and every
Rver needs one
anyway, is a digital meter that reads voltage to two decimal points
(called 3½ digits) and 20 amps of current. As long as the batteries read
12.6VDC (with nothing turned on), no charging is needed except under the
"topping off" schedule above (if at all). A perfect meter for
RVs is cheap
($40 Metex brand #M3800, JAMECO part# 27115) from JAMECO, 1355
Shoreway Rd., Belmont, CA 94002 (800) 831-4242.
Water:
Drain tank. It's almost impossible to completely drain most tanks, but a
mostly-drained tank won't freeze enough to create a burst. Many fresh
tanks have an access port on top. If you remove the plug and cover the
hole with screen, left-over water will usually evaporate. Problem might be
when you get back and have crud in tank if it didn't evaporate fast enough
or was stored in a warm place. No big deal. It can be treated and flushed
again with the "freshener" sold in
RV stores.
Disconnect pump line and make sure pump
doesn't have water in it (or it WILL freeze and WILL damage pump). Pump,
if left with water in it, will also grow disgustingly-colored algae before
you get back.
Drain water heater. Attach "blow out"
plug (any RV
store) with tire-filler-type air valve (called Schrader valves) to the
RV's city water
input. One at a time, open faucet handles, turn on compressed air and let
water and crud blow out the line. (If you've never done this, you'll be
amazed at what comes out of there.) Go to open next one a bit before fully
closing previous faucet. Repeat. Caution: if you
close everything and let air pressure run, you could blow a water line.
Sewage tanks:
Dump and wash out (as best you can, but you needn't be too fastidious).
Close valves. Disconnect hose (slinky) and clean it and store it. Before
closing valves the final time, I suggest cleaning them thoroughly and
giving them a coat of silicone grease (see later). If you don't do this,
the "O" rings and seals WILL stick and you'll end up with leaks after you
return and use them.
Propane:
Turn it off at tank. Make sure auto-safety-shutoff isn't turned on and
using electricity. You might wrap regulator in a piece of mesh or screen
to keep bugs--spiders especially--from building a nest in the vent hole.
Toilet:
You can fill bowl with water to keep seals lubricated. The water will
evaporate in a few weeks (depending where you park). I've found that
leaving the toilet empty, but carefully cleaning seal and coating it with
plumbers silicone grease (any hardware store, it's used to lubricate
faucet valves) works better and lasts over a year. Vaseline works, but not
as well.
Shower and sink drains:
The water in them will evaporate also. No problem with seals in this case,
but the RV will
stink when you get back. Pour an ounce of cooking oil (slowly) into them
to keep the water from evaporating.
Tires and underside:
Air tires to normal pressure and cover to prevent sun from rotting side
walls. If good tires, no problem. If lousy, you'll need to replace them
anyway when you get back. Do not completely wrap tires (or you'll end up
with critters making a home in there).
Sprinkle abundant "Comet" cleanser or
"Green Light" ant killer (far better) all around anything touching the
ground. Ants and such won't (usually) be a bother. If you're fortunate
enough to have a caretaker, the ant killer can be reapplied as needed
after rains (or snow?).
Make sure holes on underside (into
RV) are either
plugged with stainless-steel wool (not regular steel wool) pot scrubber
pieces or taped with aluminum duct tape (not just the gray tape). Either
will keep (usually) rodents out.
Gas Tank: Here's where you can screw up
the whole thing if you don't do it right...
- Just before going into storage, you need
to get the tank pretty near empty. Then (or before if you're a careful
planner), go to auto store and get "Stor-Gas" or similar gas
treatment. This is NOT the alcohol crap they sell to absorb water in gas
tanks (which you should never use anyway). This is stuff that people put
into lawn mower and boat engines during the "off" season. Ask for help
if you need it. Read label carefully to determine how many ounces of the
brand you buy will treat how many gallons of gas. Good auto stores will
have large cans of this stuff which is cheaper. Discount stores will
have tiny bottles of same stuff for small engines like lawn mowers (cost
more but it's the same thing). Buy what they call for, plus a bit more.
- On your last drive before going into
storage, with tank fairly empty, pour Stor-Gas in and fill the tank with
fuel. Then store your rig. The Stor-Gas will have permeated your whole
gas system (including carb or injectors) by the time you park. This
maneuver will keep your gas from turning into a sludgy varnish paste
(which gasoline WILL do if left in a tank, without this treatment, for
more than a few months). Do NOT neglect this step, you don't want a fuel
system full of varnish.
Diesel
systems are treated similarly. Check with auto store or, better yet, with
a "John Deere" store for proper chemical. (I have done all this and
left RV in
storage for over 2 years and it started right up--but see below.)
ENGINE:
Let's assume some things. Before you put your
RV in storage,
you'll have done the above, had transmission serviced (including change of
fluid), lubed and changed oil and filter.
• It isn't necessary to remove spark plugs
and squirt oil in each cylinder then reinsert plugs unless the
RV will be in
storage for more than a year.
• If it will be in storage more than six
months, you should get a pint of "Marvel Mystery Oil" and when you
run the engine the last time, at idle, air cleaner removed, slowly pour
oil into main (front) carb throttle bores (or throttle body air inlet on
fuel injection systems). When down to about ½ a pint, pour faster to stall
engine out. Do not start it again. Your cylinders and upper valve train
will be nicely coated with preservative oil.
• There's little to do in the engine
compartment. Cover air cleaner with screen or aluminum foil. Taped with
aluminum duct tape to keep critters from getting into the filter element.
Some people spread moth balls around, but I can't see that it does much
good. If you park in a rodent-infested area they may very well eat wire
insulation, hoses, etc., anyway.
Removing from storage:
- Don't forget to clear the air cleaner.
- Inspect hoses, fuel lines (the only
rubber the critters ate in AZ), general wiring and belts (they eat those
too).
- Make sure you clean out critter nests.
- Check radiator water.
- Check transmission fluid.
- Check batteries.
- Check power steering fluid.
- Change oil and filter
(it will have turned acidy if you've been gone more than six months).
- Do not start engine up right
away. Disconnect coil wire (check manual--some
vehicles need a different step) and turn engine over several seconds to
get oil up to valve train, etc.
- Reconnect coil and start engine. In most
cases, it will start right up. Sometimes, gas at carburetor or injectors
will have evaporated. Pump the hell out of the thing and it'll usually
start.
- Don't drive it until
you have run it through all the gears a few times.
- Make sure brakes are OK.
Sometimes critters chew the flexible lines near wheels.
Answers
to some questions:
- Don't leave heat and electricity on
(unless you have a caretaker).
- Don't forget to turn off AC circuit
breakers to unused circuits.
- Don't forget to pull fuses to unused 12
volt circuits--especially the water pump.
- Reefer:
Clean it out! Never leave it running with anything in it if you or
reliable caretaker aren't there (if electricity is disconnected or your
LP tank runs out (even if going away for a short time, you do NOT want
your reefer to quit while it has food in it), you'll have the equivalent
of a dead body in your
RV--no fun to
clean up). Some people put an open can of coffee in to keep fresh smell.
I prop door open and use lightly-wadded newspapers and an open box of
baking soda.
- Should you cover windows on inside with
aluminum foil? Loosely only. Too tight a seal can crack a window if heat
builds up. There are enough natural air leaks in most
RVs so
closing it up is OK.
- An uncovered plastic garbage can with
about 20-30 gal of water in it will evaporate and provide enough
humidity to prevent cracking and peeling inside for a few months.
- Cover roof vents.
Plywood boxes and bricks aren't usually needed and can become deadly
missiles in a storm. Scraps of foam or bubble-packaging material taped
down (and over air conditioner and reefer vent) are ordinarily OK.
- Solar panels shouldn't need a cover.
- A screen cap
over end of exhaust pipe, more screen or ready-made screens over furnace
and water heater vents along with a screen taped to inside of reefer
rear access panel helps.
-
Are all the storage steps necessary? Depends on how long it will
be stored. The Stor-Gas/diesel stabilizer step is recommended for 2
months or more, water draining for 3 months.
phred Tinseth © 1998-2002 Reproduction
Permitted
Web site:
http://www.phrannie.org
|